Dynamic-Biosensors-logo

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

तपशील

  • उत्पादनाचे नाव: heliX cyto Normalization Solution (Red Dye)
  • ऑर्डर क्रमांक: NOR-R2
  • For scIC measurements in the red channel
  • फक्त संशोधनासाठी वापरा
  • Limited shelf life – please check expiry date on label

प्रमुख वैशिष्ट्ये

  • हेलीएक्ससायटो चिपच्या स्पॉट 1 आणि स्पॉट 2 वरील फ्लोरोसेंट सिग्नलच्या सामान्यीकरणासाठी
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

उत्पादन वर्णन

  • ऑर्डर क्रमांक: NOR-R2

तक्ता 1. सामग्री आणि स्टोरेज माहिती

साहित्य टोपी Concentr ation रक्कम स्टोरेज
Normalization solution-R2 लाल 10 µM 6x 100 µL -20°C
  • फक्त संशोधनासाठी वापरा.
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

तयारी

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4लेबल केलेल्या विश्लेषक सोल्युशनमध्ये डाईची एकाग्रता
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

पातळ केलेले द्रावण 2-8°C तापमानात 7 दिवसांपर्यंत साठवले जाऊ शकते.

अर्जाची नोंद
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    फ्लोरोफोर एकाग्रता मापनामध्ये वापरल्या जाणाऱ्या विश्लेषक एकाग्रतेवर तसेच विश्लेषकाच्या लेबलिंगच्या डिग्रीवर अवलंबून असते. उच्च डीओएल आणि उच्च विश्लेषक एकाग्रतेसाठी, उत्तेजनाची शक्ती कमी करणे आवश्यक असू शकते.
  • अपेक्षित बंधनकारक सिग्नल
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • चिप प्रकार
    वेगवेगळ्या चिप प्रकारांमध्ये वेगवेगळ्या फ्लोरोसेंट पार्श्वभूमी असतात. चिपवर जितके मोठे सापळे आणि जास्त सापळे तितके पार्श्वभूमी सिग्नल जास्त. म्हणून, L5 चिप्सना M5 चिप्सवर लागू करण्यापेक्षा कमी उत्तेजनाची शक्ती आवश्यक असू शकते.

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 M5 चिप

विश्लेषण डाई conc. = विश्लेषक conc x DOL उत्तेजना शक्ती एकाग्रता सामान्यीकरण उपाय सौम्यता सामान्यीकरण उपाय
25 nM 0.5 25 nM १६:१०
50 nM 0.3 50 nM १६:१०
100 nM 0.2 100 nM १६:१०
300 nM 0.1 300 nM १६:१०
500 nM 0.08 500 nM १६:१०
1 µM 0.05 1 µM १६:१०
2.5 µM 0.02 2.5 µM १६:१०

टीप: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

संपर्क करा

डायनॅमिक बायोसेन्सर्स GmbH
Perchtinger Str. 8/10 81379 Munich, Germany

ब्रुकर सायंटिफिक एलएलसी
40 Manning Road, Manning Park, Billerica, MA 01821 USA

www.dynamic-biosensors.com
उपकरणे आणि चिप्स जर्मनीमध्ये तयार आणि तयार केल्या जातात. ©२०२५ डायनॅमिक बायोसेन्सर्स GmbH केवळ संशोधन वापरासाठी. क्लिनिकल डायग्नोस्टिक प्रक्रियांमध्ये वापरण्यासाठी नाही.

वारंवार विचारले जाणारे प्रश्न

What is the shelf life of the heliX cyto Normalization Solution?

उत्पादनाचे शेल्फ लाइफ मर्यादित आहे. विशिष्ट माहितीसाठी कृपया लेबलवरील कालबाह्यता तारीख तपासा.

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

कागदपत्रे / संसाधने

Dynamic Biosensors helix cyto Normalization Solution [pdf] वापरकर्ता मॅन्युअल
helix cyto Normalization Solution, helix cyto, Normalization Solution, Solution

संदर्भ

एक टिप्पणी द्या

तुमचा ईमेल पत्ता प्रकाशित केला जाणार नाही. आवश्यक फील्ड चिन्हांकित आहेत *