COMET SP042 LoraWAN Gateway Kit
तपशील
- मॉडेल: सेन्सकॅप एम२
- Wx9xx मालिका ट्रान्समीटरसाठी पर्यायी अॅक्सेसरीज
वर्णन आणि वापर
The gateway serves as an access point for the local LoRaWAN® network and is designed to connect COMET Wx9xx series transmitters to the COMET Cloud via the LoRaWAN® network. The gateway is a third-party product, supplied with complete original accessories for its power supply and installation.
However, it is preset so that after installation, it immediately starts receiving data messages from the LoRaWAN® network with its antenna, supplements them with the correct time of message reception, and sends the complete data to the target server used by the COMET Cloud. The condition is a connection to a network with available Internet, without restrictions on the outgoing direction from the gateway, e.,g. by a firewall.
A DHCP server must also be available in this network.
The gateway is configured via WiFi; see the original device manual. Under normal circumstances, it is not necessary to interfere with the gateway configuration, as it is already set.
चेतावणी
If you reset the gateway to factory settings, all presets will be lost! Registering a gateway to the COMET Cloud is done in the Administration / LoRa Gateways menu. Add your gateway to the list by entering its Gateway EUI identifier (for this gateway, it is the EUI item from the label on the bottom of the device).
You can also give it a suitable name and, if it will be placed stationary, we recommend entering its location on the map. Connect the gateway as shown in the image below. To maintain cybersecurity, we recommend connecting the gateway to a separate VLAN. Connect the registered gateway to power. Within a few minutes, its status in the gateway list in the COMET Cloud must change to ONLINE (you must refresh the web page manually). The green indicator on the front (white) surface of the gateway must then be permanently green.
शिफारस केलेले गेटवे कनेक्शन
The SenseCAP M2 is a gateway that is used to connect with Wx9xx series transmitters. It is configured via WiFi and allows for seamless integration into the COMET Cloud for data transmission and monitoring.
गेटवे नोंदणी
To register the gateway to the COMET Cloud, follow these steps:
- Access the Administration / LoRa Gateways menu on the COMET Cloud platform.
- Enter the Gateway EUI identifier (found on the label at the bottom of the device).
- Assign a suitable name to the gateway, and input its location on the map will be stationary.
जोडणी
Follow these steps to connect the gateway:
- Connect the gateway as per the provided instructions.
- For cybersecurity reasons, connect the gateway to a separate VLAN.
- Power up the gateway and wait for it to show ONLINE status on The COMET can be a loud platform.
- The three indicators on the front of the gateway should be permanently green once connected.
COMET SYSTEM, sro, Bezrucova 2901 तपशील सूचना न देता बदलू शकतात.
756 61 Roznov pod Radhostem, Czech Republic IE-WFS-N-SP042-02
वारंवार विचारले जाणारे प्रश्न
What should I do if I need to reset the gateway?
Resetting the gateway to factory settings will result in the loss of all presets. Exercise caution and only reset if necessary.
कागदपत्रे / संसाधने
 |
COMET SP042 LoraWAN Gateway Kit [pdf] सूचना पुस्तिका SP042, SP042 LoraWAN Gateway Kit, LoraWAN Gateway Kit, Gateway Kit |