विशेष TC1 टर्बो कनेक्ट डिस्प्ले वापरकर्ता मार्गदर्शक

सामग्री लपवा

Verifying TurboConnect software version is up to date

Power on the device and wait until the device is fully booted (This will take a few minutes)
- The device is fully booted when the LED indicator switches from trailing white (booting) to solid blue (idle)
Once fully booted, the charger’s Wi-Fi access point will be visible and be displayed as the serial number. Using a laptop/desktop, connect to this access point using the Wi-Fi password found in the manual as shown below.
- Wi-Fi password found in manual
  Note: This password is unique for each charger
- प्रवेश बिंदूशी कनेक्ट करत आहे
एकदा कनेक्ट झाल्यावर, ए उघडा web browser (such as Google Chrome, Microsoft Edge, etc) and go to https://172.20.0.1 to access the device’s web UI

वर लॉगिन करा Web UI using the following credentials:
- वापरकर्तानाव: प्रशासक
- Password: Found in the manual as Master Password (Unique per device)

Once successfully authenticated, you will land on the home page of the Web UI. Navigate to the “System” tab, then scroll down to the Software Information section If the Comboard SW Version is under 3.2.2, please visit this link to download the updated software version: – Link here
Then continue with the following steps to update the TurboConnect
In the same page, navigate to Firmware Update and select the ﬁle downloaded from the above link

Once the ﬁle has been selected, the update will begin. When the update is complete, the system will reboot. (The update will take a few minutes)
Wait until the update is complete, the system has reboot, and until the Wi-Fi access point is visible again