1. उत्पादन संपलेview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
प्रमुख वैशिष्ट्ये:
- Capable of pumping water down to 2 mm residual level.
- पूर्णपणे सबमर्सिबल डिझाइन.
- Handles dirt particles up to 3 mm in size.
- Equipped with a 10-meter power cable.
- Features a practical carry handle for easy transport.
आकृती 1: ओव्हरview of the Sicce Ultrazero Flat Sucking Pump.
2. सुरक्षितता माहिती
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- हाताळणी, साफसफाई किंवा कोणतीही देखभाल करण्यापूर्वी पंप नेहमी वीज पुरवठ्यापासून डिस्कनेक्ट करा.
- वीज पुरवठा व्हॉल्यूमची खात्री कराtage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- मुलांना आणि अनधिकृत व्यक्तींना ऑपरेटिंग क्षेत्रापासून दूर ठेवा.
- Ensure the pump is fully submerged during operation to prevent overheating.
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. सेटअप आणि स्थापना
Follow these steps to properly set up your Ultrazero pump:
- पंप अनपॅक करा: पॅकेजिंगमधून पंप आणि सर्व अॅक्सेसरीज काळजीपूर्वक काढा. कोणतेही नुकसान झाले आहे का ते तपासा.
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.
Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- पंपची जागा निश्चित करा: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- वीज कनेक्शन: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.
Figure 3: The flat base of the pump designed for low residual water levels.
4. ऑपरेटिंग सूचना
The Ultrazero pump is designed for simple operation:
- पंप बुडवा: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- पंपिंग सुरू करा: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- पाण्याच्या पातळीचे निरीक्षण करा: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- Stop Pumping: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.
Figure 4: The Ultrazero pump effectively draining water from a small pool.
Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.
Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. देखभाल
नियमित देखभालीमुळे तुमच्या पंपचे दीर्घायुष्य आणि इष्टतम कामगिरी सुनिश्चित होते.
- स्वच्छता: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- मोडतोड तपासा: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- केबल तपासणी: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- स्टोरेज: When not in use, store the pump in a clean, dry place, protected from frost.
Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
6. समस्या निवारण
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| समस्या | संभाव्य कारण | उपाय |
|---|---|---|
| पंप सुरू होत नाही. | वीजपुरवठा नाही. पॉवर केबल खराब झाली. Motor overload protection activated. | पॉवर कनेक्शन आणि आउटलेट तपासा. Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| पंप चालू आहे पण पाणी सोडले जात नाही. | Intake blocked. डिस्चार्ज नळी वाकलेली किंवा ब्लॉक झालेली. Airlock in pump. | Disconnect power, clear intake. डिस्चार्ज नळी तपासा आणि साफ करा. Briefly lift and lower the pump while submerged to release trapped air. |
| पंपिंग कामगिरी कमी झाली. | Partial blockage. Impeller worn. | Disconnect power, clean pump intake and impeller area. सेवेसाठी ग्राहक समर्थनाशी संपर्क साधा. |
| पंप अनपेक्षितपणे थांबतो. | Overheating due to low water level or blockage. इलेक्ट्रिकल बिघाड. | Disconnect power, check water level and clear blockages. Allow to cool. समस्या कायम राहिल्यास, ग्राहक समर्थनाशी संपर्क साधा. |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. तांत्रिक तपशील
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| तपशील | मूल्य |
|---|---|
| ब्रँड | Sicce |
| मॉडेल क्रमांक | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 ली/ता |
| कमाल वितरण उंची | 3.1 मी |
| Power Consumption (P1) | 80 प |
| संचालन खंडtage | 220-240V/50Hz |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| प्रेशर कनेक्शन | 26.44 mm (3/4") AG |
| नळी कनेक्शन व्यास | १२.५ मिमी (१/२") |
| Max. Solids Size | 3 मिमी |
| अवशिष्ट पाणी पातळी | Down to 2-3 mm |
| उत्पादनाचे परिमाण (अंदाजे) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| आयटम वजन | 2.6 किलो (5.72 पौंड) |
| फ्लोट स्विच | नाही |
| ओव्हरलोड संरक्षण | No (Internal thermal protection may exist, but no external reset) |
| मूळ | इटली मध्ये केले |
Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. हमी आणि समर्थन
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
निर्माता: एबारा
ब्रँड: Sicce
For further assistance, visit the official Sicce webतुमच्या स्थानिक वितरकाच्या वेबसाइटवर जा किंवा संपर्क साधा.